Brady Wraptor Podręcznik Użytkownika Pobierz pdf (Strona 31)

Step 1. Initiate Ribbon Load in Control Panel

From the Wraptor Control Panel, select SETUP  LOAD RIBBON.

Step 2. Open the Wraptor Unit

Lift the side door of the Wraptor unit.

Figure 10. Wraptor with Side Door Open

Follow the steps below to load the ribbon.

NOTE: Ribbon threading instructions are also located on

the inside of the side door.

Step 3. Remove the Old Ribbon

If ribbon is currently loaded, remove it:

 Cut the ribbon between the guide bar and take-up spool.

 Hold the edge of the take-up spool while turning the knob clockwise until it stops.

 Pull the take-up spool knob to remove the used ribbon from the take-up spool and

discard.

 Re-engage the take-up spool by pushing it in all the way until the knob auto-rotates back

to its original position. Failure to re-engage the take-up spool will make it difficult to

remove the old ribbon next time!

 Remove remaining ribbon, if any, from the feed spool.

 Use tape to secure the end of the ribbon roll.

24 Wraptor™ User’s Guide

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Brak uwag

Brady Wraptor Podręcznik Użytkownika Strona 31